Disassembly [02/2019 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE FUEL SENDER GAUGE ASSEMBLY
See step 7 [02/2019 - 08/2020], or see step 7 [08/2020 - 12/2021], or see step 7 [12/2021 - 10/2022], or see step 7 [10/2022 - 10/2023], or see step 7 [10/2023 - ]
- REMOVE FUEL PUMP
- Detach the 4 claws and disconnect the sub-assembly support from the fuel sub-tank sub-assembly.
- Disconnect the connector from the fuel pump.
- Detach the 3 claws and remove the No. 1 cap from the sub-assembly support.
- Remove the fuel pump from the sub-assembly support.
- Remove the O-ring from the sub-assembly support.
- Remove the spacer from the fuel pump.
- Detach the 4 claws and disconnect the sub-assembly support from the fuel sub-tank sub-assembly.