Inspection [11/2018 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT DIRECT FUEL INJECTOR ASSEMBLY
NOTE:
This inspection is for checking the direct fuel injector assembly for an open or short. Because the direct fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
| Tester Connection |
Condition |
Specified Condition |
| 1 - 2 |
20°C (68°F) |
1.34 to 1.64 Ω |
If the result is not as specified, replace the direct fuel injector assembly.