Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL:
| The monitor will run whenever the following DTCs are not stored | P0112, P0113 (IAT (Intake air temperature) sensor circuit) P0717, P07BF, P07C0 (Turbine speed sensor circuit) P0793, P07C5, P07C6 (Intermediate shaft speed sensor circuit) P0962, P0963 (Solenoid (SL1) valve circuit) P0966, P0967 (Solenoid (SL2) valve circuit) P0970, P0971 (Solenoid (SL3) valve circuit) P2814, P2815 (Solenoid (SL4) valve circuit) P281D, P281E (Solenoid (SL5) valve circuit) P08C1, P08C2 (Solenoid (SL6) valve circuit) P0743 (Solenoid (SL) valve circuit) P2759 (Solenoid (SLU) valve circuit) P0117, P0118 (ECT (Engine coolant temperature) sensor circuit) P0712, P0713 (ATF temperature sensor circuit (TFT sensor)) P0327, P0328, P0332, P0333 (KCS sensor circuit) P0121, P0122, P0123, P0222, P0223, P0604, P0606, P060A, P060B, P060D, P060E, P061E, P0657, P0658, P2102, P2103, P2111, P2112, P2119, P2135 ((ETCS) Electronic throttle control system) U0100 (CAN communication system) P0335 (Crankshaft position sensor "A" circuit) P2610 (Soak timer circuit) |
CONDITION (A)
| Time after engine start except for continuing shift position "N" or "P"*2 | 11 min. and 40 seconds or more |
| Accumulated driving time *1 | 3 min. and 50 seconds or more |
| Driving distance after engine start*3 | 6 km (3.7 miles) or more |
| IAT*4 | 15°C (59°F) or higher |
| ECT (12 seconds after engine start) | 15°C (59°F) or higher |
| Soak time | 5 hours or more |
CONDITION (B):
| Time after engine start except for continuing shift position "N" or "P"*2 | 18 min. and 20 seconds or more |
| Accumulated driving time*1 | 6 min. or more |
| Driving distance after engine start*3 | 7 km (4.3 mile) or more |
| IAT*4 | -10°C (14°F) or higher |
| ECT (12 seconds after engine start) | -10°C (14°F) or higher |
CONDITION (C):
| Time after engine start except for continuing shift position "N" or "P"*2 | 30 min. or more |
| Accumulated driving time*1 | 9 min. and 40 seconds or more |
| Driving distance after engine start*3 | 15 km (9.3 mile) |
| IAT*4 | -15°C (5°F) or higher |
| ECT (12 seconds after engine start) | -15°C (5°F) or higher |
CONDITION (D):
| Time after engine start except for continuing shift position "N" or "P"*2 | 40 min. or more |
| Accumulated driving time*1 | 12 min. and 50 seconds or more |
| Driving distance after engine start*3 | 20 km (12.4 mile) |
CONDITION (E):
| Any of the following conditions is met | - |
| - Elapsed time for ECT to reach 60°C (140°F) | 10 seconds or more |
| - Soak time | 5 hours or more |
| ATF temperature (12 seconds after engine start) | 100°C (212°F) or higher |
| ECT (12 seconds after engine start) | Below 35°C (95°F) |
HINT:
*1: Following conditions are met
| Engine speed - Turbine speed | -50 rpm or more |
| Output speed | 400 rpm or more |
| Throttle valve opening angle | 3% or more |
| Shift position | Not "N" or "P" |
| Engine | Starting |
| Accumulated driving time is cleared when following condition met | - |
| Duration time from shift position "N" or "P" | 300 seconds or more |
*2: Time after engine start is cleared when following condition met
| Duration time from shift position "N" or "P" | 300 seconds or more |
*3: Driving distance is cleared when following condition met
| Duration time from shift position "N" or "P" | 300 seconds or more |
*4: IAT is measured when either of following conditions met
| 12 seconds after engine start | - |
| Duration time from shift position "N" or "P" | 300 seconds or more |