Caution / Notice / Hint
- Perform the universal trip to clear permanent DTCs.
Refer to DTC CHECK / CLEAR [11/2018 - ]
- Perform registration and/or initialization when parts related to the automatic transaxle are replaced.
Refer to PRECAUTION [11/2018 - 08/2020]
- If DTCs P0710-00, P2610-29 and/or P2610-93 are output simultaneously, using the Techstream, check if the ATF temperature is as specified under the "Normal Condition" column of the Data List. If the ATF temperature is as specified under the "Normal Condition" column, perform troubleshooting for DTC P2610-29.
w/ Canister Pump Module: Refer to DTC P2610-29: ECM/PCM Engine Off Timer Performance Signal Invalid; DTC P2610-93: ECM/PCM Engine Off Timer Performance No Operation [11/2018 - 08/2020]
w/o Canister Pump Module: Refer to DTC P2610-29: ECM/PCM Engine Off Timer Performance Signal Invalid [11/2018 - 08/2020]
- DATA LIST NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- Warm up the engine.
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Transmission / Data List / A/T Oil Temperature No. 1.
- Read the Data List according to the display on the Techstream.
Powertrain > Transmission > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note A/T Oil Temperature No. 1 ATF temperature sensor value Min.: -40°C (-40°F)
Max.: 150°C (302°F)- Approximately 80°C (176°F): After stall speed test
- Equal to ambient temperature: When engine is cold
If value is -40°C (-40°F) or 150°C (302°F), ATF temperature sensor circuit is open or shorted Powertrain > Transmission > Data List
Tester Display A/T Oil Temperature No. 1 HINT:
- If DTC P0710-11 is output and the Techstream indicates 150°C (302°F) or higher, there is a short in the circuit.
- If DTC P0710-15 is output and the Techstream indicates -40°C (-40°F), the circuit is open.
Check the temperature displayed on the Techstream in order to check if a malfunction exists.
Temperature Displayed Malfunction -40°C (-40°F) Open circuit 150°C (302°F) or higher Short circuit - If a circuit related to the ATF temperature sensor becomes open, P0710-15 will be stored in approximately 0.5 seconds. If DTC P0710-15 is stored, DTC P0710-00 cannot be detected. It is not necessary to inspect the circuit when P0710-00 is output.