DTC P0705-13: Transmission Range Sensor "A" Circuit Open; DTC P0705-62: Transmission Range Sensor "A" Signal Compare Failure [11/2018 - ]: Description

WARNING: This page is about a different variant/trim than selected.

The park/neutral position switch assembly detects the shift lever position and sends signals to the ECM.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory	Note
P0705-13	Transmission Range Sensor "A" Circuit Open	When the ignition switch is ON and battery voltage is 8 V or higher, NSW, P, R, N and D input signals are all OFF simultaneously for 60 seconds or more (2-trip detection logic).	Park/neutral position switch assembly Open in park/neutral position switch assembly circuit ECM	Comes on	DTC stored	SAE Code: P0705
P0705-62	Transmission Range Sensor "A" Signal Compare Failure	When the ignition switch is ON and battery voltage is 8 V or higher, 2 or more of the following signals are ON simultaneously for 2 seconds or more (2-trip detection logic). NSW, P or N input signal R input signal D input signal	Park/neutral position switch assembly Short in park/neutral position switch assembly circuit ECM	Comes on	DTC stored	SAE Code: P0705

DTC DETECTION CONDITION PATTERNS (P0705-62):

		Vehicle Condition
		Pattern 1	Pattern 2	Pattern 3	Pattern 4
Diagnostic Condition	Ignition switch is ON	◦	◦	◦	◦
Diagnostic Condition	Battery voltage is 8 V or higher	◦	◦	◦	◦
Malfunction Condition	NSW input signal is ON	◦	◦	-	-
	P input signal is ON	-	-	◦	◦
	R input signal is ON	-	◦	-	◦
	N input signal is ON	-	-	-	-
	D input signal is ON	◦	-	◦	-
Duration		2 seconds or more	2 seconds or more	2 seconds or more	2 seconds or more
Detection Logic		2-trip detection logic	2-trip detection logic	2-trip detection logic	2-trip detection logic

DTC DETECTION CONDITION PATTERNS (P0705-62):

		Vehicle Condition
		Pattern 5	Pattern 6	Pattern 7
Diagnostic Condition	Ignition switch is ON	◦	◦	◦
Diagnostic Condition	Battery voltage is 8 V or higher	◦	◦	◦
Malfunction Condition	NSW input signal is ON	-	-	-
	P input signal is ON	-	-	-
	R input signal is ON	-	◦	◦
	N input signal is ON	◦	◦	-
	D input signal is ON	◦	-	◦
Duration		2 seconds or more	2 seconds or more	2 seconds or more
Detection Logic		2-trip detection logic	2-trip detection logic	2-trip detection logic

HINT:

DTC P0705-62 is stored when any of the above detection patterns is met.