LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 111 (Automatic Transaxle System (UB80F) - Service Information (2 Of 3)) >> Shift Paddle Switch >> Removal [10/2019 - 08/2020] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system Refer to PRECAUTION [11/2018 - 12/2021]
Perform steering sensor zero point calibration Lane control system Refer to INITIALIZATION [11/2018 - 12/2021]
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system Refer to INITIALIZATION [11/2018 - 10/2022]
Panoramic view monitor system (for Gasoline model) Refer to INITIALIZATION [11/2018 - 10/2022]
Reset back door close position Power back door system (for Gasoline model) Refer to INITIALIZATION [11/2018 - 10/2023]
Back door lock initialization Power door lock control system Refer to INITIALIZATION [11/2018 - ]

*: When performing learning using the Techstream.

NOTE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

WAITING TIME BEFORE DISCONNECTING CABLE FROM NEGATIVE (-) BATTERY TERMINAL

System Name See Procedure
Vehicle enrolled in Toyota Audio Multimedia system or safety connect system 6 minutes
Vehicle not enrolled in Toyota Audio Multimedia system and safety connect system 1 minute