LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 110 (Transfer Case System (GF2A) - Service Information) >> Transfer Assembly >> Removal [10/2019 - 08/2020] >> Procedure

Removal [10/2019 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE TRANSAXLE ASSEMBLY 

    Refer to REMOVAL [10/2019 - 08/2020]

  2. REMOVE PROPELLER SHAFT HEAT INSULATOR 

    Refer to PROCEDURE - Step 18

  3. REMOVE NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY 
    1. Remove the 2 bolts and No. 1 propeller shaft heat insulator bracket sub-assembly.
      GTY875274Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 25 N.m (255 kgf/cm, 18 ft.lbf) 

  4. REMOVE REAR ENGINE MOUNTING INSULATOR 

    Refer to PROCEDURE - Step 19

  5. REMOVE REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 20

  6. REMOVE TRANSFER ASSEMBLY 
    1. GTY869878Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 8 nuts and transfer assembly from the transaxle.

  7. REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT 

    Refer to PROCEDURE - Step 30

  8. REMOVE WIRING HARNESS CLAMP BRACKET 
    1. Disconnect the 3 clamps and 2 connectors.
      GTY875409Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 bolts, 3 wiring harness clamp brackets and clutch control solenoid wire.
      GTY934370Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals