LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 110 (Transfer Case System (GF2A) - Service Information) >> Transfer Assembly >> Disassembly [10/2019 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • When replacing the rear drive pinion companion flange and rear transfer case oil seal, be sure to check the preload.
  • If the output shaft companion flange sub-assembly and rear transfer case oil seal were replaced without checking the preload, replace the transfer assembly.
  • Before installation of each part, thoroughly clean and dry it. Then apply grease or oil as necessary. Do not use alkaline chemicals to clean aluminum parts, rubber parts or precoated bolts. Also, do not use non-residue solvent or other cleaning oils to clean oil seals or rubber parts.
scientia non olet · About LEMON Manuals