LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 110 (Transfer Case System (GF2A) - Service Information) >> 4WD Control Ecu >> Removal [11/2018 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the 4WD control ECU assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
4WD ECU assembly
  • ECU data save
  • ECU data initialization
  • ECU data write
 Dynamic torque vectoring AWD system Refer to CALIBRATION [11/2018 - ]
scientia non olet · About LEMON Manuals