LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Lighting System (W/ AFS) - Diagnostic Codes & Circuit Tests) >> LIGHTING SYSTEM (w/ AFS) >> Front Side Marker Light Circuit [02/2019 - 12/2021] >> Procedure

Front Side Marker Light Circuit [02/2019 - 12/2021]: Procedure

WARNING: This page is about a different car, the 2021 Toyota RAV4, 2020 Toyota RAV4, and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK LIGHTS 
    1. Check the illumination of each front side marker light.

      Result

      Result Proceed to
      LH side front side marker light does not illuminate A
      RH side front side marker light does not illuminate B

    Result: 

    See step  7

    Result: 

    See step  2

  2. PERFORM ACTIVE TEST USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / AFS / Active Test.
    5. Perform the Active Test according to the display on the Techstream.

      Body Electrical > AFS > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Clearance Light Parking lights OFF or ON -

      Body Electrical > AFS > Active Test 

      Tester Display
      Clearance Light

      OK

      Front side marker light illuminates.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [02/2019 - 08/2020]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2020 - 12/2021] 

    Result: 

    NG 

    See step  3

  3. CHECK HEADLIGHT UNIT ASSEMBLY LH AND BULB SOCKET (FRONT SIDE MARKER LIGHT SOCKET AND WIRE) LH 
    1. Interchange the headlight unit assembly LH with RH and connect the connectors.

      Refer to REMOVAL [02/2019 - 12/2021]

    2. Interchange the bulb socket (front side marker light socket and wire) LH with RH and connect the connectors.

      Refer to REPLACEMENT [02/2019 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  4

  4. CHECK OPERATION (FRONT SIDE MARKER LIGHT) 
    1. Check the operation of front side marker light.

      Result

      Result Proceed to
      LH side front side marker light does not illuminate A
      RH side front side marker light does not illuminate B

    Result: 

    REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [02/2019 - 12/2021] 

    Result: 

    See step  5

  5. CHECK BULB SOCKET (FRONT SIDE MARKER LIGHT SOCKET AND WIRE) LH 
    1. Interchange the bulb socket (front side marker light socket and wire) LH with RH and connect the connectors.

      Refer to REPLACEMENT [02/2019 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  6

  6. CHECK OPERATION (FRONT SIDE MARKER LIGHT) 
    1. Check the operation of front side marker light.

      Result

      Result Proceed to
      LH side front side marker light does not illuminate A
      RH side front side marker light does not illuminate B

    Result: 

    REPLACE HEADLIGHT UNIT ASSEMBLY LH. Refer to  REMOVAL [02/2019 - 12/2021] 

    Result: 

    REPLACE BULB SOCKET (FRONT SIDE MARKER LIGHT SOCKET AND WIRE) LH. Refer to  REPLACEMENT [02/2019 - ] 

  7. PERFORM ACTIVE TEST USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / AFS (Sub) / Active Test.
    5. Perform the Active Test according to the display on the Techstream.

      Body Electrical > AFS (Sub) > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Clearance Light Parking lights OFF or ON -

      Body Electrical > AFS (Sub) > Active Test 

      Tester Display
      Clearance Light

      OK

      Front side marker light illuminates.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [02/2019 - 08/2020]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2020 - 12/2021] 

    Result: 

    NG 

    See step  8

  8. CHECK HEADLIGHT UNIT ASSEMBLY RH AND BULB SOCKET (FRONT SIDE MARKER LIGHT SOCKET AND WIRE) RH 
    1. Interchange the headlight unit assembly RH with LH and connect the connectors.

      Refer to REMOVAL [02/2019 - 12/2021]

    2. Interchange the bulb socket (front side marker light socket and wire) RH with LH and connect the connectors.

      Refer to REPLACEMENT [02/2019 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  9

  9. CHECK OPERATION (FRONT SIDE MARKER LIGHT) 
    1. Check the operation of front side marker light.

      Result

      Result Proceed to
      RH side front side marker light does not illuminate A
      LH side front side marker light does not illuminate B

    Result: 

    REPLACE HEADLIGHT ECU SUB-ASSEMBLY RH. Refer to  REMOVAL [02/2019 - 12/2021] 

    Result: 

    See step  10

  10. CHECK BULB SOCKET (FRONT SIDE MARKER LIGHT SOCKET AND WIRE) RH 
    1. Interchange the bulb socket (front side marker light socket and wire) RH with LH and connect the connectors.

      Refer to REPLACEMENT [02/2019 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  11

  11. CHECK OPERATION (FRONT SIDE MARKER LIGHT) 
    1. Check the operation of front side marker light.

      Result

      Result Proceed to
      RH side front side marker light does not illuminate A
      LH side front side marker light does not illuminate B

    Result: 

    REPLACE HEADLIGHT UNIT ASSEMBLY RH. Refer to  REMOVAL [02/2019 - 12/2021] 

    Result: 

    REPLACE BULB SOCKET (FRONT SIDE MARKER LIGHT SOCKET AND WIRE) RH. Refer to  REPLACEMENT [02/2019 - ]