DTC B2450: Height Sensor Initialization Incomplete [02/2019 - 12/2021]: Procedure
WARNING: This page is about a different car, the 2021 Toyota RAV4, 2020 Toyota RAV4, and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- INITIALIZATION HEADLIGHT ECU SUB-ASSEMBLY LH
- Perform initialization of the headlight ECU sub-assembly LH.
Refer to INITIALIZATION [02/2019 - 12/2021]
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Perform initialization of the headlight ECU sub-assembly LH.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / AFS / Clear DTCs.
- Clear the DTCs.
Body Electrical > AFS > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 3
- CHECK FOR DTC
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / AFS / Trouble Codes.
- Check for DTCs.
Body Electrical > AFS > Trouble Codes
OK
DTC B2450 is not output.
HINT:
If the headlight ECU sub-assembly LH stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the headlight ECU sub-assembly LH.
Result
Proceed to OK NG
Result:
OK
END (INITIALIZATION WAS NOT COMPLETED)
Result:
NG
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to REMOVAL [02/2019 - 12/2021]