Headlight Beam Level Control Actuator Circuit [11/2018 - 12/2021]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON (READY)*1 or start the engine*2.
   1. *1: for HV Model
   2. *2: for Gasoline Model
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / HL AutoLeveling / Active Test.
5. Perform the Active Test according to the display on the Techstream.

   Body Electrical > HL AutoLeveling > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Drive The Leveling Motor	Headlight leveling motor upward or downward operation	Stop, Down or Up	Perform the Active Test with the ignition switch is ON (READY)*1 or the engine started*2 and vehicle stopped

   1. *1: for HV Model
   2. *2: for Gasoline Model

   Body Electrical > HL AutoLeveling > Active Test 

   Tester Display
   Drive The Leveling Motor

   OK

   Headlight leveling motors operate normally.

   Result

   Result	Proceed to
   OK	A
   NG (for LH Side)	B
   NG (for RH Side)	C

Result: 

A 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [11/2018 - 08/2020]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2020 - 12/2021] 

Result: 

C 

See step  4

Result: 

B 

See step  2

1. Interchange the headlight unit assembly LH with RH and connect the connectors.

   for Triple Beam Headlight:

   Refer to DISASSEMBLY [11/2018 - 08/2020] , or refer to DISASSEMBLY [08/2020 - 10/2022]

   for Single Beam Headlight:

   Refer to DISASSEMBLY [11/2018 - 02/2019] , or refer to DISASSEMBLY [02/2019 - 08/2020] , or refer to DISASSEMBLY [08/2020 - 12/2021]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Check that the headlight leveling motor LH operates normally.

   Refer to OPERATION CHECK [11/2018 - 08/2020] , or refer to OPERATION CHECK [08/2020 - 12/2021]

   OK

   Headlight leveling motor LH operates normally.

   Result

   Result	Proceed to
   OK	A
   NG (for Triple Beam Headlight)	B
   NG (for Single Beam Headlight)	C

Result: 

A 

REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [11/2018 - 02/2019]  , or refer to  REMOVAL [02/2019 - 12/2021] 

Result: 

B 

REPLACE HEADLIGHT UNIT ASSEMBLY LH. Refer to  DISASSEMBLY [11/2018 - 08/2020]  , or refer to  DISASSEMBLY [08/2020 - 10/2022] 

Result: 

C 

REPLACE HEADLIGHT UNIT ASSEMBLY LH. Refer to  DISASSEMBLY [11/2018 - 02/2019]  , or refer to  DISASSEMBLY [02/2019 - 08/2020]  , or refer to  DISASSEMBLY [08/2020 - 12/2021] 

1. Interchange the headlight unit assembly RH with LH and connect the connectors.

   for Triple Beam Headlight:

   Refer to DISASSEMBLY [11/2018 - 08/2020] , or refer to DISASSEMBLY [08/2020 - 10/2022]

   for Single Beam Headlight:

   Refer to DISASSEMBLY [11/2018 - 02/2019] , or refer to DISASSEMBLY [02/2019 - 08/2020] , or refer to DISASSEMBLY [08/2020 - 12/2021]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Check that the headlight leveling motor RH operates normally.

   Refer to OPERATION CHECK [11/2018 - 08/2020] , or refer to OPERATION CHECK [08/2020 - 12/2021]

   OK

   Headlight leveling motor RH operates normally.

   Result

   Result	Proceed to
   OK	A
   NG (for Triple Beam Headlight)	B
   NG (for Single Beam Headlight)	C

Result: 

A 

REPLACE HEADLIGHT ECU SUB-ASSEMBLY RH. Refer to  REMOVAL [11/2018 - 02/2019]  , or refer to  REMOVAL [02/2019 - 12/2021] 

Result: 

B 

REPLACE HEADLIGHT UNIT ASSEMBLY RH. Refer to  DISASSEMBLY [11/2018 - 08/2020]  , or refer to  DISASSEMBLY [08/2020 - 10/2022] 

Result: 

C 

REPLACE HEADLIGHT UNIT ASSEMBLY RH. Refer to  DISASSEMBLY [11/2018 - 02/2019]  , or refer to  DISASSEMBLY [02/2019 - 08/2020]  , or refer to  DISASSEMBLY [08/2020 - 12/2021]