DTC P2614-01: Camshaft Position Signal Output "A" General Electrical Failure [06/2020 - 08/2020]: Procedure
WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
- Replace the cam timing control motor with EDU assembly.
Refer to REMOVAL [02/2019 - 08/2020]
HINT:
Perform "Inspection After Repair" after replacing the cam timing control motor with EDU assembly.
Refer to INITIALIZATION [10/2019 - 08/2020]
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Replace the cam timing control motor with EDU assembly.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Clear the DTCs.
Powertrain > Engine > Clear DTCs
- Turn the ignition switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 3
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P2614-01 is output B
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [02/2019 - 08/2020]