DTC P2610-29: ECM/PCM Engine Off Timer Performance Signal Invalid; DTC P2610-93: ECM/PCM Engine Off Timer Performance No Operation [06/2020 - 08/2020]: Procedure

WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

REPLACE ECM

Replace the ECM.

Refer to REMOVAL [02/2019 - 08/2020]

Result

Proceed to
NEXT

Result:

See step 2

CLEAR DTC

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTCs.
Powertrain > Engine > Clear DTCs

Turn the ignition switch off and wait for at least 30 seconds.

Result

Proceed to
NEXT

Result:

See step 3

CHECK WHETHER DTC OUTPUT RECURS (DTC P2610-29 OR P2610-93)

Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / Trouble Codes.

Read the Pending DTCs.

Powertrain > Engine > Trouble Codes

HINT:

If no pending DTC is output, the repair has been successfully completed.

Result

Proceed to
NEXT

Result:

END