DTC P064A-49: Fuel Pump Control Module Internal Electronic Failure [02/2019 - 06/2020]: Procedure
WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Clear the DTCs.
Powertrain > Engine > Clear DTCs
- Turn the ignition switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 2
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P064A-49)
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P064A-49 is output A DTC P064A-49 and other DTCs are output B
Result:
A
REPLACE FUEL PUMP CONTROL ECU. Refer to REMOVAL [02/2019 - 08/2020]
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [02/2019 - 10/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2019 - 06/2020]