Vehicle Control History [02/2019 - 06/2020]

WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CHECK VEHICLE CONTROL HISTORY (SFI SYSTEM)

HINT:

Vehicle control history (SFI system) is stored when Switch Specification Information learning is incomplete.
Perform Switch Specification Information after replacing the ECM.

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.

Enter the following menus: Powertrain / Engine / Utility / Vehicle Control History (RoB).

Powertrain > Engine > Utility

Tester Display
Vehicle Control History (RoB)

HINT:

It is also possible to display Vehicle Control History during the Health Check, if "Store All Data" isselected.

VEHICLE CONTROL HISTORY ITEM

Code	Item	Trigger Description	Stored Group	Reference Inspection Procedure	Link
X260E	Active Grille Air Shutter Specification Information Learning Incomplete	Switch Specification Information learning is incomplete.	-	Perform Switch Specification Information.	Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020]

Vehicle Control History Freeze Frame Data

VEHICLE CONTROL HISTORY (AIRBAG SYSTEM)
HINT:

A part of the control history can be confirmed using the vehicle control history.

Refer to VEHICLE CONTROL HISTORY [02/2019 - 08/2020]
VEHICLE CONTROL HISTORY (HYBRID CONTROL SYSTEM)
HINT:

A part of the control history can be confirmed using the vehicle control history.

Refer to VEHICLE CONTROL HISTORY [02/2019 - ]