Typical Enabling Conditions
WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
ALL
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | - |
| Auxiliary battery voltage | 8 V or higher |
| Ignition switch | On |
| Time after ignition switch off to ON | 0.5 seconds or more |
CASE 1
| Either of the following conditions is met | A or B |
| A. Both of the following conditions are met | - |
| Auxiliary battery voltage | 11 V or higher, and less than 13 V |
| Target duty cycle | Less than 70% |
| B. Both of the following conditions are met | - |
| Auxiliary battery voltage | 13 V or higher |
| Target duty cycle | Less than 80% |
CASE 2
| Both of the following conditions are met | - |
| Current cut status | Not cut |
| Target duty cycle | 25% or higher |