DTC P0011-00: Camshaft Position "A" - Timing Over-Advanced or System Performance Bank 1 [02/2019 - 06/2020]: Procedure

WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0011-00)

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine / Trouble Codes.

Read the DTCs.

Powertrain > Engine > Trouble Codes

Result

Result	Proceed to
DTC P0011-00 is output	A
DTC P0011-00 and other DTCs are output	B

HINT:

If any DTCs other than P0011-00 are output, troubleshoot those DTCs first.

Result:

GO TO DTC CHART

Refer to DIAGNOSTIC TROUBLE CODE CHART [02/2019 - 10/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2019 - 06/2020]

Result:

See step 2

REPLACE CAMSHAFT TIMING GEAR ASSEMBLY

Replace the camshaft timing gear assembly.

Refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 06/2020]

HINT:

Perform "Inspection After Repair" after replacing the camshaft timing gear assembly.

Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020]

Result

Proceed to
NEXT

Result:

See step 3

CLEAR DTC

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTCs.
HINT:

Clear the DTC without using the Techstream.

Turn the ignition switch off and wait for at least 30 seconds.

Result

Proceed to
NEXT

Result:

See step 4

CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED

Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / Trouble Codes.

Read the DTCs.

Powertrain > Engine > Trouble Codes

Result

Result	Proceed to
DTCs are not output	A
DTC P0011-00 is output	B

Result:

END

Result:

REPLACE ECM

Refer to REMOVAL [02/2019 - 08/2020]