DTC B162A: Side Airbag Sensor Assembly No. 2 (RH) [02/2019 - 08/2020]: Procedure
WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FLOOR SIDE AIRBAG SENSOR RH
- Turn the ignition switch off.
*1 Floor Side Airbag Sensor LH *2 Airbag ECU Assembly - Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.
- Interchange the floor side airbag sensor RH with LH and connect the connectors to them.
- Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
- Turn the ignition switch to ON, and wait for at least 60 seconds.
- Clear the DTCs stored in memory.
Refer to DTC CHECK / CLEAR [11/2018 - 08/2020]
Body Electrical > SRS Airbag > Clear DTCs
- Turn the ignition switch off.
- Turn the ignition switch to ON, and wait for at least 60 seconds.
- Check for DTCs.
Refer to DTC CHECK / CLEAR [11/2018 - 08/2020]
Body Electrical > SRS Airbag > Trouble Codes
Result
Proceed to DTC B162A is output DTC B163A is output DTCs B162A and B163A are not output HINT:
Codes other than DTCs B162A and B163A may be output at this time, but they are not related to this check.
- Turn the ignition switch off.
- Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.
- Return the floor side airbag sensor LH and RH to their original positions and connect the connectors to them.
Result:
DTC B162A is output
REPLACE AIRBAG ECU ASSEMBLY. Refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 08/2020]
Result:
DTC B163A is output
REPLACE FLOOR SIDE AIRBAG SENSOR RH. Refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 08/2020]
Result:
DTCs B162A and B163A are not output
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
- Turn the ignition switch off.