DTC B1615: Front Airbag Sensor (LH) [11/2018 - 02/2019]: Procedure
WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FRONT AIRBAG SENSOR LH
- Turn the ignition switch off.
*1 Front Airbag Sensor RH *2 Airbag ECU Assembly - Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
- Interchange the front airbag sensor LH with RH and connect the connectors to them.
- Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
- Turn the ignition switch to ON, and wait for at least 60 seconds.
- Clear the DTCs stored in memory.
Refer to DTC CHECK / CLEAR [11/2018 - 08/2020]
Body Electrical > SRS Airbag > Clear DTCs
- Turn the ignition switch off.
- Turn the ignition switch to ON, and wait for at least 60 seconds.
- Check for DTCs.
Refer to DTC CHECK / CLEAR [11/2018 - 08/2020]
Body Electrical > SRS Airbag > Trouble Codes
Result
Proceed to DTC B1615 is output DTC B1610 is output DTCs B1610 and B1615 are not output HINT:
Codes other than DTC B1610 and B1615 may be output at this time, but they are not related to this check.
- Turn the ignition switch off.
- Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
- Return the front airbag sensor RH and LH to their original positions and connect the connectors to them.
Result:
DTC B1615 is output
REPLACE AIRBAG ECU ASSEMBLY. Refer to REMOVAL [11/2018 - 02/2019]
Result:
DTC B1610 is output
REPLACE FRONT AIRBAG SENSOR LH. Refer to REMOVAL [11/2018 - 02/2019]
Result:
DTCs B1610 and B1615 are not output
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
- Turn the ignition switch off.