LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Hybrid Control System (2WD, W/ Nickel Metal Hydride Battery) - Diagnostic Codes (1 Of 6)) >> HYBRID CONTROL SYSTEM (for 2WD with NICKEL METAL HYDRIDE BATTERY) >> DTC P0705-62: Transmission Range Sensor "A" Circuit (PRNDL Input) Signal Compare Failure [11/2018 - 08/2020] >> Description

DTC P0705-62: Transmission Range Sensor "A" Circuit (PRNDL Input) Signal Compare Failure [11/2018 - 08/2020]: Description

WARNING: This page is about a different car, the 2020 Toyota RAV4 and 2019 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

The shift lever position sensor sends 7 different switch signals to the hybrid vehicle control ECU assembly. The hybrid vehicle control ECU assembly uses these signals to detect the shift lever position (P, R, N or D). The hybrid vehicle control ECU assembly also uses this information to determine the intended direction of travel (forward or reverse).

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0705-62 Transmission Range Sensor "A" Circuit (PRNDL Input) Signal Compare Failure Shift sensor circuit malfunction (abnormal pattern)
A malfunction in the P, R, N or D circuit is detected based on the shift sensor input pattern.
(1 trip detection logic)
  • Wire harness or connector
  • Shift lever position sensor
  • Hybrid vehicle control ECU assembly
Does not come on Master Warning:
Comes on
RELATED DATA LIST

DTC No. Data List
P0705-62
  • Shift Position
  • Shift Position Sensor (PNB)
  • Shift Position Sensor (PR)
  • Shift Position Sensor (DB1)
  • Shift Position Sensor (DB2)
  • Shift Position Sensor (N)
  • Shift Position Sensor (R)
  • Shift Position Sensor (P)