LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System / Washer System - Service Information >> Washer Motor >> Removal [11/2018 - 08/2020] >> Procedure

Removal [11/2018 - 08/2020]: Procedure

  1. REMOVE FRONT WHEEL 

    Refer to REMOVAL [11/2018 - ]

  2. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH (for Long Type) 
    1. Remove the 4 screws.
      GTY940686Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the claw and remove the front fender front splash shield RH.
  3. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH (for Short Type) 
    1. Remove the 3 screws.
      GTY940690Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the claw and remove the front fender front splash shield RH.
  4. REMOVE FRONT FENDER MUDGUARD RH (w/ Mudguard) 
    1. for Short Type:

      HINT: 

      Use the same procedure described for the LH side.

      Refer to PROCEDURE - Step 1

    2. for Long Type:

      HINT: 

      Use the same procedure described for the LH side.

      Refer to PROCEDURE - Step 3

  5. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 10 [11/2018 - 10/2019] , or refer to PROCEDURE - Step 10 [10/2019 - 08/2020]

  6. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH (except Off Road Package) 

    HINT: 

    Use the same procedure described for the LH side.

    Refer to PROCEDURE - Step 1

  7. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH (for Off Road Package) 

    HINT: 

    Use the same procedure described for the LH side.

    Refer to PROCEDURE - Step 2

  8. REMOVE FRONT FENDER LINER RH 
    1. w/ Mudguard:
      1. Remove the 8 clips and 2 screws.
        GTY914328Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *A w/o Mudguard - -
        Clip Screw
    2. w/o Mudguard:
      1. Remove the 9 clips and 2 screws.
    3. Using a screwdriver with its tip wrapped with protective tape, detach the claw and remove the 4 grommets.
      GTY904024Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the front fender liner RH.
  9. DRAIN WINDSHIELD WASHER FLUID 
    1. Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.
      GTY940694Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use a container to collect the washer fluid.

  10. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY 
    1. Disconnect the washer hose from the windshield washer motor and pump assembly.
      GTY850370Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      Washer hose
      Connector
    2. Disconnect the connector.
    3. Remove the windshield washer motor and pump assembly as shown in the illustration.
  11. REMOVE FRONT BUMPER COVER 
    1. except Off Road Package:

      Refer to REMOVAL [11/2018 - 02/2019] , or refer to REMOVAL [02/2019 - 08/2020]

    2. for Off Road Package:

      Refer to REMOVAL [11/2018 - 02/2019] , or refer to REMOVAL [02/2019 - 08/2020]

  12. REMOVE WASHER INLET SUB-ASSEMBLY 
    1. Remove the clip.
      GTY856127Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hand Here
      Remove in this Direction
    2. Place your hands at the position shown in the illustration and remove the washer inlet sub-assembly in the direction indicated by the arrow.
  13. REMOVE WINDSHIELD WASHER JAR ASSEMBLY 
    1. Detach the clamp and disconnect the washer hose.
      GTY904038Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the clamp.
      GTY867336Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Level Warning Switch
    3. w/ Level Warning Switch:
      1. Disconnect the connector.
    4. Remove the 3 bolts. Then detach the guide and remove the windshield washer jar assembly.
      GTY904036Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE LEVEL WARNING SWITCH ASSEMBLY (w/ Level Warning Switch) 

    See step  3 [11/2018 - 02/2019], or see step  3 [02/2019 - ]