Removal [08/2020 - 12/2021]: Procedure

PRECAUTION

WARNING:

Be sure to read precaution thoroughly before servicing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PRECAUTION [08/2020 - ]

NOTE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [11/2018 - ]

REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 2
REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 3
REMOVE BATTERY HOLE COVER
Refer to PROCEDURE - Step 4

DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Disconnect the cable from the negative (-) auxiliary battery terminal.

Refer to PROCEDURE - Step 5

WARNING:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

NOTE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2020 - 12/2021]

REMOVE HYBRID VEHICLE CONTROL ECU ASSEMBLY
Refer to REMOVAL [08/2020 - 12/2021]

REMOVE VEHICLE APPROACHING SPEAKER CONTROLLER

Remove the bolt.

Detach the guide and remove the vehicle approaching speaker controller.
NOTE:
- When removing the vehicle approaching speaker controller, take care not to damage it.
- Do not reuse a vehicle approaching speaker controller that has been dropped or subjected to a strong shock.