DTC B1ACC-71: Rear Door Right Speaker Cable Actuator Stuck [10/2022 - ]: Procedure

Pre-procedure1

1. Disconnect the M2 stereo component amplifier assembly connector.
2. Disconnect the K1 rear speaker assembly RH connector.

   Procedure1

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   M2-12 (RR+) - K1-2 (+)	Always	Below 1 Ω
   M2-27 (RR-) - K1-1 (-)	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

   Post-procedure1

4. None

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

Refer to INSPECTION [11/2018 - ]

Result

Result: 

NG 

REPLACE REAR SPEAKER ASSEMBLY RH 

Refer to REMOVAL [11/2018 - ]

Result: 

OK 

See step  3

1. Clear the DTCs.

   Body Electrical > Navigation System > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. In accordance with the display of the GTS, perform a speaker line electricity check.

   Body Electrical > Navigation System > Utility 

   Tester Display
   Speaker Line Electricity Check

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Check for DTCs and proceed to the following step.

   Body Electrical > Navigation System > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC B1ACC-71 is output	B

Result: 

A 

END 

Result: 

B 

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY 

Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]