Caution / Notice / Hint

NOTE:

When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

A communication malfunction DTC may be stored.
The radio and display receiver assembly may not operate normally.

HINT:

When a large amount of data is in a USB device, it may take a while to begin playback.
When using a USB device, files that are protected by copyright cannot be played.
When files are not played in the sorted order, perform the following procedure before inspection.
1. Add numbers in front of the file names.
2. Put the files in a folder and copy the folder data to the USB device.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Refer to PRECAUTION [11/2018 - 10/2019]