Slip Indicator Light does not Come ON [08/2021 -]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT COMBINATION METER ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Perform the Active Test of the combination meter assembly using the Techstream.
Refer to DATA LIST / ACTIVE TEST [08/2021 -]
Body Electrical > Combination Meter > Active Test
Tester Display Slip Warning - Check the combination meter assembly.
OK
The slip indicator light turns on or off in accordance with Techstream operation.
Result
Proceed to OK NG
Result:
OK
REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to REMOVAL [08/2021 -]
Result:
NG
INSPECT METER / GAUGE SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 -]