LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Prius XLE >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Air Conditioning System (Service Information) (2 Of 2)) >> COMPRESSOR (for A25A-FXS) >> Removal [08/2021 -] >> Procedure

Removal [08/2021 -]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 

    Refer to PROCEDURE - Step 1

  2. REMOVE SERVICE PLUG GRIP 

    Refer to REMOVAL [08/2021 -]

  3. CHECK TERMINAL VOLTAGE 
    1. Disconnect the engine room main wire.

      Refer to PROCEDURE - Step 2

    2. Remove the connector cover assembly.

      Refer to PROCEDURE - Step 9

    3. Check the terminal voltage.

      Refer to PROCEDURE - Step 10

    4. Install the connector cover assembly.

      Refer to PROCEDURE - Step 6

    5. Connect the engine room main wire.

      Refer to PROCEDURE - Step 19

  4. REMOVE RADIATOR ASSEMBLY 

    Refer to REMOVAL [08/2021 -]

  5. DISCONNECT SUCTION HOSE SUB-ASSEMBLY 
    1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor with motor assembly.
      GTY945530Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the suction hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  6. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE SUB-ASSEMBLY 
    1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose sub-assembly from the compressor with motor assembly.
      GTY925825Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the No. 1 cooler refrigerant discharge hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  7. REMOVE COMPRESSOR WITH MOTOR ASSEMBLY 
    1. Using a screwdriver, slide the green-colored lock of the connector (A) as shown in the illustration to release it and disconnect the connector.
      GTY854712Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Connector (A)
      *b Connector (B)
      *c Green-colored Lock
      Slide
      WARNING:

      Make sure to wear insulated gloves.

      NOTE:

      Insulate the disconnected terminals and connector with insulating tape.

    2. Disconnect the connector (B).
    3. Remove the bolt and 2 nuts.
      GTY850054Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Nut
    4. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor with motor assembly.
      GTY925789Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals