More/Less Fuel than the Actual Amount is Displayed [11/2021 - ]: Procedure

1. Turn the ignition switch to ON.
2. Read the DTC of [Combination Meter] using the GTS.

   Body Electrical > Combination Meter > Trouble Codes 

   Is DTC B1500 displayed? (Current code)

   Result	Proceed to
   YES (Perform the diagnosis for the displayed DTCs.)	A
   NO	B

Result: 

A 

PERFORM THE DIAGNOSIS FOR THE DISPLAYED DTCS. 

Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 10/2024] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2024 - ]

Result: 

B 

See step  2

1. Start the engine.
2. Using the GTS, read all DTCs.

   Is DTC U**** displayed? (Current code)

   Result	Proceed to
   YES (Perform the diagnosis according to the basic diagnostic procedure in CAN SYSTEM (DIAGNOSTICS).)	A
   NO	B

Result: 

A 

PERFORM THE DIAGNOSIS ACCORDING TO THE BASIC DIAGNOSTIC PROCEDURE IN CAN SYSTEM (DIAGNOSTICS). 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]

Result: 

B 

See step  3

1. Using the GTS, check the following items in the [Active Test] of [Combination Meter].

   Body Electrical > Combination Meter > Active Test 

   Tester Display	Measurement Item	Diagnostic Note
   E-Lock	Fuel receiver gauge	-
   E dial	Fuel receiver gauge	-
   Low fuel warning indicate point	Fuel receiver gauge	-
   1/4 dial	Fuel receiver gauge	-
   1/2 dial	Fuel receiver gauge	-
   3/4 dial	Fuel receiver gauge	-
   F dial	Fuel receiver gauge	-
   F-Lock	Fuel receiver gauge	-

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   E-Lock

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   E dial

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Low fuel warning indicate point

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   1/4 dial

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   1/2 dial

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   3/4 dial

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   F dial

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   F-Lock

   Do the indicated amount on GTS and the fuel gauge indication match?

   Result	Proceed to
   YES (Check the fuel sender gauge assembly as a single part.)	A
   NO (Replace the combination meter assembly.)	B

Result: 

A 

CHECK THE FUEL SENDER GAUGE ASSEMBLY AS A SINGLE PART 

Refer to INSPECTION [11/2021 - 12/2023] , or refer to INSPECTION [12/2023 - ]

Result: 

B 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [11/2021 - ]