Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear trailing arm assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PROCEDURE PERFORMED
| Replaced Part or Performed Procedure |
Necessary Procedure |
Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
| Rear wheel alignment adjustment |
for HEV Model:
- Perform "Reset Memory"
- Perform "Calibration"
|
- DTCs are stored
- ABS warning light illuminates
- Brake system warning light (yellow indicator) illuminates
- Slip indicator light illuminates
- Electronically controlled brake system does not operate correctly
|
Refer to UTILITY [11/2022 - ] |
for Gasoline Model:
- Perform "Reset Memory"
- Perform "Calibration"
|
- DTCs are stored
- ABS warning light illuminates
- Slip indicator light illuminates
- Electronically controlled brake system does not operate correctly
|
Refer to UTILITY [11/2022 - ] |
for Gasoline Model AWD:
- Perform "Reset Memory"
|
Dynamic torque control AWD system |
Refer to CALIBRATION [09/2021 - ] |
| Suspension, tires, etc. |
Rear television camera assembly optical axis (Back camera position setting) |
Parking Assist Monitor System |
Refer to CALIBRATION [11/2022 - ] |
| Initialize headlight ECU subassembly LH |
Automatic headlight beam level control system |
Refer to INITIALIZATION [11/2022 - ] |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.