LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Corolla Cross L, AWD >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column - Service Information >> Steering Column Assembly >> Removal [09/2021 - 11/2022] >> Procedure

Removal [09/2021 - 11/2022]: Procedure

  1. REMOVE STEERING WHEEL ASSEMBLY 

    Refer to REMOVAL [09/2021 - 11/2022] 

  2. REMOVE LOWER STEERING COLUMN COVER 
    GTY993405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    Removing the lower steering column cover in the incorrect order will cause the parts to break.
    1. GTY1034189Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Push Push Area
      1. Remove the 3 screws.
      2. While pressing the push area shown in the illustration to disengage the claws, slightly lower the lower steering column cover.
  3. REMOVE UPPER STEERING COLUMN COVER 
    1. GTY1033295Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE TRANSPONDER KEY COIL (w/o Smart Key System) 
    1. GTY1033286Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY 
    GTY993405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:
    • Do not remove/install the spiral cable with sensor sub-assembly with the auxiliary battery connected and the ignition switch ON.
    • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the auxiliary battery connected and the ignition switch ON.
    • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
    1. GTY1034194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Clamp - -
      Down - -
      1. Disconnect each connector.

        HINT: 

        As the illustration shown is an example, the actual details may differ.

      2. Using pliers, expand the clamp.
      3. While holding the clamp expanded, raise the claw using a screwdriver to disengage it, and then remove the turn signal switch assembly with spiral cable sub-assembly from the steering column assembly.
  6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY 

    Refer to REMOVAL [09/2021 - 11/2022]

  7. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER 

    Refer to REMOVAL [09/2021 - ]

  8. REMOVE COLUMN HOLE COVER SILENCER SHEET 
    1. GTY1033765Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Open Place Hand Here
  9. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY 
    1. GTY1033395Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Matchmark - -
      1. Put matchmarks on the No. 2 steering intermediate shaft assembly and steering gear assembly.
      2. Remove the bolt to disconnect the No. 2 steering intermediate shaft assembly from the steering gear assembly.
  10. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY 
    1. GTY1033198Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Matchmark - -
      1. Put matchmarks on the No. 2 steering intermediate shaft assembly and steering column assembly.
      2. Remove the bolt and No. 2 steering intermediate shaft assembly from the steering column assembly.
  11. REMOVE STEERING COLUMN ASSEMBLY 
    1. GTY1034539Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals