Inspection [11/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Corolla Cross, 2024 Toyota Corolla Cross, and 2023 Toyota Corolla Cross. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT OIL PRESSURE CONTROL VALVE ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 6.2 to 8.2 Ω If the result is not as specified, replace the oil pressure control valve assembly.
*a Component without harness connected
(Oil Pressure Control Valve Assembly) - Connect an auxiliary battery positive (+) lead to terminal 1 and a negative (-) lead to terminal 2.
Check that a clicking sound is heard from the oil pressure control valve assembly.
*a Component without harness connected
(Oil Pressure Control Valve Assembly)NOTE:- Check that the auxiliary battery voltage is between 10 and 16 V before performing this test.
- Perform this test within 10 seconds to prevent the coil from burning out.
- Always switch the voltage on and off at the auxiliary battery side, not the oil pressure control valve assembly side.
If the result is not as specified, replace the oil pressure control valve assembly.
- Measure the resistance according to the value(s) in the table below.