DTC P0571-13: Brake Switch "A" Circuit Open [11/2023 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Corolla Cross, 2024 Toyota Corolla Cross, and 2023 Toyota Corolla Cross. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY OUTPUT CIRCUIT)
- Make sure that there is no looseness at the locking part and the connecting part of the connector.
OK
The connector is securely connected.
*a Component with harness connected
(Stop Light Switch Assembly) - Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition A53-3 (L) - Body ground Brake pedal depressed 11 to 14 V A53-3 (L) - Body ground Brake pedal released Below 1.5 V Result
Proceed to OK NG
Result:
NG
REPLACE STOP LIGHT SWITCH ASSEMBLY. Refer to REMOVAL [09/2021 - ]
Result:
OK
See step 2
- Make sure that there is no looseness at the locking part and the connecting part of the connector.
- CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY INPUT CIRCUIT)
- Make sure that there is no looseness at the locking part and the connecting part of the connector.
OK
The connector is securely connected.
*a Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly)) - Disconnect the A151 skid control ECU (brake actuator assembly) connector.
- Check both the connector case and the terminals for deformation and corrosion.
OK
No deformation or corrosion.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition A151-4 (STP) - Body ground Brake pedal depressed 11 to 14 V Result
Proceed to OK NG
Result:
OK
REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to REMOVAL [11/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
- Make sure that there is no looseness at the locking part and the connecting part of the connector.