Inspection [11/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Corolla Cross, 2024 Toyota Corolla Cross, and 2023 Toyota Corolla Cross. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY)
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 6 (DRV) - 5 (E) Drive mode select switch (combination switch assembly) being pushed and held Below 1 Ω Drive mode select switch (combination switch assembly) not pushed 10 kΩ or higher If the result is not as specified, replace the drive mode select switch (combination switch assembly).
- Measure the resistance according to the value(s) in the table below.
- Check illumination.
- Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the drive mode select switch (combination switch assembly).
*a Component without harness connected
(Drive Mode Select Switch (Combination Switch Assembly))Standard
Measurement Condition Specified Condition Auxiliary battery positive (+) → 4 (ILL+)
Auxiliary battery negative (-) → 1 (ILL-)Illuminates If the result is not as specified, replace the drive mode select switch (combination switch assembly).
- Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the drive mode select switch (combination switch assembly).
- Check the resistance.