LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Corolla Cross L, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Hybrid Battery Control System - Service Information) >> Combination Switch >> Inspection [11/2022 - ] >> Procedure

Inspection [11/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Corolla Cross, 2024 Toyota Corolla Cross, and 2023 Toyota Corolla Cross. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT EV DRIVE MODE SWITCH (COMBINATION SWITCH ASSEMBLY) 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.
        GTY1113997Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (EV Drive Mode Switch (Combination Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        I61-8 (S) - I61-5 (E) EV drive mode switch (combination switch assembly) being pushed and held Below 50 Ω
        EV drive mode switch (combination switch assembly) not pushed 10 kΩ or higher

        If the result is not as specified, replace the EV drive mode switch (combination switch assembly).

    2. Check illumination.
      1. Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the EV drive mode switch (combination switch assembly).

        Standard

        Measurement Condition Specified Condition
        Auxiliary battery positive (+) → I61-4 (ILL+)
        Auxiliary battery negative (-) → I61-1 (ILL-)        		 Illuminates

        If the result is not as specified, replace the EV drive mode switch (combination switch assembly).

        GTY850896Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (EV Drive Mode Switch (Combination Switch Assembly))
  2. INSPECT DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.
        GTY1113998Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Drive Mode Select Switch (Combination Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        I61-6 (DRV) - I61-5 (E) Drive mode select switch (combination switch assembly) being pushed and held Below 50 Ω
        Drive mode select switch (combination switch assembly) not pushed 10 kΩ or higher

        If the result is not as specified, replace the drive mode select switch (combination switch assembly).

    2. Check illumination.
      1. Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the drive mode select switch (combination switch assembly).
        GTY850896Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Drive Mode Select Switch (Combination Switch Assembly))

        Standard

        Measurement Condition Specified Condition
        Auxiliary battery positive (+) → I61-4 (ILL+)
        Auxiliary battery negative (-) → I61-1 (ILL-)        		 Illuminates

        If the result is not as specified, replace the drive mode select switch (combination switch assembly).

scientia non olet · About LEMON Manuals