LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Corolla Cross L, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Engine Control System (M20A-FXS) - Diagnostic Codes (4 Of 6)) >> SFI System >> DTC P060E-49: Internal Control Module Throttle Position Performance Internal Electronic Failure [11/2022 - ] >> Procedure

DTC P060E-49: Internal Control Module Throttle Position Performance Internal Electronic Failure [11/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Corolla Cross, 2024 Toyota Corolla Cross, and 2023 Toyota Corolla Cross. However, it is still accessible from the selected car via links, so may be relevant.
  1. CLEAR DTC 
    1. Clear the DTCs.

      Powertrain > Engine > Clear DTCs 

    2. Turn the ignition switch off.

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. READ OUTPUT DTC (DTC P060E-49) 
    1. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
    2. Connect the cable to the negative (-) auxiliary battery terminal.
    3. Turn the ignition switch to ON.
    4. Wait 16 seconds or more.
    5. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      DTCs are not output A
      DTC P060E-49 is output B

    Result: 

    CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [11/2022 - ] 

    Result: 

    REPLACE ECM. Refer to  REMOVAL [11/2022 - ]