LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Corolla Cross L, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Hybrid Battery System - Diagnostic Codes (1 Of 2)) >> Hybrid Battery System >> Registration / Initialization / Learning [11/2022 - ] >> Registration / Initialization / Learning [11/2022 - ]

Registration / Initialization / Learning [11/2022 - ]

WARNING: This page is about a different car, the 2025 Toyota Corolla Cross, 2024 Toyota Corolla Cross, and 2023 Toyota Corolla Cross. However, it is still accessible from the selected car via links, so may be relevant.
  1. HIGH VOLTAGE FUSE ACCUMULATED LOAD HISTORY RESET 

    HINT: 

    If the HV battery junction block assembly has been replaced, make sure to perform "High Voltage Fuse Accumulated Load History Reset" and then clear the DTCs.

    DTC P0A95-63 will be stored again if do not perform "High Voltage Fuse Accumulated Load History Reset".

    1. Enter the following menus.

      Powertrain > HV Battery > Utility 

      Tester Display
      High Voltage Fuse Accumulated Load History Reset
    2. According to the display on the GTS, perform High Voltage Fuse Accumulated Load History Reset and check that "High Voltage Fuse Accumulated Load History Reset is complete." is displayed.
      NOTE:
      • Performing High Voltage Fuse Accumulated Load History Reset takes approximately 20 to 25 minutes.
      • Make sure to confirm that "High Voltage Fuse Accumulated Load History Reset is complete." is displayed on GTS.
      • If "High Voltage Fuse Accumulated Load History Reset has failed. Do you want to try again?" is displayed on the GTS, perform the procedure again.
    3. Turn the ignition switch off.