Recirculated/Fresh Air Modes do not Switch [11/2022 - ]: Procedure
- CHECK NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY
- Check that the No. 1 blower damper servo sub-assembly is installed correctly.
OK
The No. 1 blower damper servo sub-assembly is installed correctly.
Result
Proceed to OK NG
Result:
NG
INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY. Refer to REASSEMBLY [09/2021 - ]
Result:
OK
See step 2
- Check that the No. 1 blower damper servo sub-assembly is installed correctly.
- CHECK FOR DTC
- Check for DTCs.
Body Electrical > Air Conditioner > Trouble Codes
Result
Result Proceed to B143A-87 and B143B-7F is not output A B143A-87 is output B B143B-7F is output C
Result:
B
GO TO DTC B143A-87. Refer to DTC B143A-87: Lost Communication with Air Inlet Damper Control Servo Motor LIN Missing Message [11/2022 - ]
Result:
C
GO TO DTC B143B-7F. Refer to DTC B143B-7F: Air Inlet Damper Control Servo Motor Actuator Stuck Off [11/2022 - ]
Result:
A
See step 3
- Check for DTCs.
- READ VALUE USING GTS
- Read the Data List according to the display on the GTS.
Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up This is the engine coolant temperature.
HINT:- After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).
- After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.
- If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.
- Check if the engine overheats if the value indicated is higher than 135°C (275°F).
Powertrain > Engine > Data List
Tester Display Coolant Temperature OK
After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.
Result
Proceed to OK NG
Result:
OK
REPLACE AIR CONDITIONER UNIT ASSEMBLY. Refer to REMOVAL [11/2022 - ]
Result:
NG
GO TO COOLING SYSTEM. Refer to ON-VEHICLE INSPECTION [09/2021 - ]
- Read the Data List according to the display on the GTS.