On-Vehicle Inspection [11/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Corolla Cross, 2024 Toyota Corolla Cross, and 2023 Toyota Corolla Cross. However, it is still accessible from the selected car via links, so may be relevant.
- WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
- When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator), slip indicator light, VSC OFF indicator light, brake hold standby indicator light and brake hold operated indicator light come on for approximately 3 seconds.
HINT:
- When the brake fluid level is low, the brake system warning light (red indicator) comes on.
- If the skid control ECU stores any DTCs, the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator) or slip indicator light will come on. Also, in this state, if the vehicle is under the following conditions and the brake hold switch (electric parking brake switch assembly) is turned on, the brake hold operated indicator light blinks.
- Vehicle Conditions:
- The driver door is closed.
- The driver seat belt is fastened.
- Vehicle Conditions:
- If the warning lights and indicator lights do not illuminate or illuminate for more than approximately 3 seconds, perform troubleshooting for the electronically controlled brake system.
- When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator), slip indicator light, VSC OFF indicator light, brake hold standby indicator light and brake hold operated indicator light come on for approximately 3 seconds.