LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Corolla Cross L, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Automatic Transaxle System (K121 / K121F) - Diagnostics - Introduction) >> Continuously Variable Transaxle System >> Registration [11/2023 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different car, the 2025 Toyota Corolla Cross and 2024 Toyota Corolla Cross. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When the continuously variable transaxle assembly is replaced, the transaxle compensation code must be registered to the ECM (Procedure 1).

    After the continuously variable transaxle assembly is installed, the Quick Response (QR) code label will be positioned where the code cannot be read. Therefore, before installing the continuously variable transaxle assembly, record the transaxle compensation code or register it using the GTS.

  • When the ECM is replaced, the existing transaxle compensation code must be registered to the new ECM (Procedure 2).
  • Perform Reset Memory after replacing the continuously variable transaxle parts.

    Refer to INITIALIZATION [11/2023 - ] 

scientia non olet · About LEMON Manuals