LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Corolla Cross L, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft / Propeller Shaft - Service Information (2 Of 2) >> Rear Drive Shaft Assembly >> Inspection [09/2021 - 11/2022] >> Procedure

Inspection [09/2021 - 11/2022]: Procedure

  1. INSPECT REAR DRIVE SHAFT ASSEMBLY 
    1. Check that there is no excessive play in the radial direction of the outboard joint.
      GTY223263Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the inboard joint slides smoothly in the thrust direction.
    3. Check that there is no excessive play in the radial direction of the inboard joint.
    4. Check the boots for damage.
    5. Check whether each drive shaft dimension (A) is within specification.

      Dimension (A)

      for LH Side 735.6 to 745.6 mm (2.41 to 2.45 ft.)
      for RH Side 720.1 to 730.1 mm (2.36 to 2.39 ft.)
      GTY1022016Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Keep the drive shaft assembly level during inspection.

scientia non olet · About LEMON Manuals