Caution / Notice / Hint
NOTE:
- Inspect the fuses for circuits related to this system before performing the following procedure.
- After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Refer to UTILITY [09/2021 - 11/2022]
- Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
- DTC precaution
Refer to PRECAUTION [09/2021 - 11/2022]
PROCEDURE TO CLEAR WARNING LIGHTS (WHEN NOT CLEARING DTCS)Procedure - Repair or replacement.
- Turn the ignition switch to ON.
- Drive the vehicle and depress the brake pedal 2 or 3 times to clear the warning lights.