Brake Hold Operated Indicator Light Circuit [09/2021 - 11/2022]: Procedure

1. Check that the brake hold standby indicator light operates normally.

   Refer to Brake Hold Standby Indicator Light Circuit [09/2021 - 11/2022] 

2. If the brake hold operated indicator light does not illuminate even though the brake hold standby indicator light is illuminated, check that the following brake hold operation (brake fluid pressure is being maintained) conditions are met.
   1. System is in operation standby state (brake hold standby indicator light is illuminated).
   2. Shift position is not P or R.
   3. Driver is depressing brake pedal and vehicle is fully stopped.
   4. Driver is not depressing accelerator pedal.
   5. Vehicle is not on steep decline.

   HINT: 

   If a malfunction occurs in one of the following systems, the brake hold operated indicator light will blink. If this occurs, perform troubleshooting on the malfunctioning system.

   • Brake system
   • Electric parking brake system

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Using the GTS, check for Vehicle Control History.

   Refer to VEHICLE CONTROL HISTORY (RoB) [09/2021 - 11/2022]

   Chassis > Brake/EPB > Utility 

   Tester Display
   Vehicle Control History (RoB)

   HINT: 

   If vehicle control history is stored when the electronically controlled brake system and electric parking brake system are suspended and the brake hold switch (electric parking brake switch assembly) is operated with the following vehicle conditions met, the brake hold operated indicator light blinks.

   1. The driver door is closed.
   2. The driver seat belt is fastened.

   Result

   Result	Proceed to
   There is no vehicle control history (RoB) for when the electronically controlled brake system and electric parking brake system were suspended.	A
   There is vehicle control history (RoB) for when the electronically controlled brake system and/or electric parking brake system were suspended.	B

Result: 

B 

PERFORM TROUBLESHOOTING AND REPAIR REGARDING VEHICLE CONTROL HISTORY 

Refer to VEHICLE CONTROL HISTORY (RoB) [09/2021 - 11/2022]

Result: 

A 

See step  3

1. Perform the Active Test of the combination meter assembly using the GTS.

   Refer to DATA LIST / ACTIVE TEST [09/2021 - 11/2022]

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Hold Indicator

2. Check the combination meter assembly.

   OK

   The brake hold operated indicator light turns on or off in accordance with the GTS operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to  REMOVAL [09/2021 - 11/2022] 

Result: 

NG 

INSPECT METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2021 - 11/2022]