Removal [11/2022 - ]: Procedure
- PRECAUTION NOTE:
- After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. (for HEV Model)
Refer to BEFORE DISCONNECTING BATTERY [11/2022 - 11/2023] , or refer to BEFORE DISCONNECTING BATTERY [11/2023 - ]
- Make sure to read the precautions of the electric parking brake system before removing the rear brake assembly.
Refer to PRECAUTION [11/2022 - ]
- After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. (for HEV Model)
- PERFORM REAR BRAKE PAD REPLACEMENT MODE
- for HEV model:
Refer to TEST MODE PROCEDURE [11/2022 - ]
- for Gasoline model:
Refer to TEST MODE PROCEDURE [11/2022 - ]
- for HEV model:
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for HEV Model)
Refer to REMOVAL [11/2022 - ]
- REMOVE REAR WHEEL
Refer to REMOVAL [09/2021 - ]
- DRAIN BRAKE FLUID NOTE:
If brake fluid leaks onto any painted surface, immediately wash it off.
- DISCONNECT REAR FLEXIBLE HOSE
- DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Refer to PROCEDURE - Step 4 - REMOVE PARKING BRAKE ACTUATOR ASSEMBLY
Refer to PROCEDURE - Step 5 - REMOVE DISC BRAKE CYLINDER ASSEMBLY
- REMOVE REAR DICSC BRAKE PAD KIT
- REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
Refer to PROCEDURE - Step 7 - REMOVE REAR DISC BRAKE PAD SUPPORT PLATE NOTE:
Each rear disc brake pad support plate has a different shape. Be sure to put an identification mark on each rear disc brake pad support plate so that it can be reinstalled to its original position.
- REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN
- REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH
- REMOVE REAR DISC BRAKE BUSHING DUST BOOT
- REMOVE REAR DISC BRAKE CYLINDER MOUNTING
- REMOVE REAR DISC