Removal [08/2021 -]: Procedure

Refer to PROCEDURE - Step 1

Refer to REMOVAL [08/2021 -]

1. Disconnect the engine room main wire.

   Refer to PROCEDURE - Step 2

2. Remove the connector cover assembly.

   Refer to PROCEDURE - Step 9

3. Check the terminal voltage.

   Refer to PROCEDURE - Step 10

4. Install the connector cover assembly.

   Refer to PROCEDURE - Step 6

5. Connect the engine room main wire.

   Refer to PROCEDURE - Step 19

Refer to REMOVAL [08/2021 -]

1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor with motor assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the O-ring from the suction hose sub-assembly.
   NOTE:

   Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose sub-assembly from the compressor with motor assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the O-ring from the No. 1 cooler refrigerant discharge hose sub-assembly.
   NOTE:

   Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

1. Using a screwdriver, slide the green-colored lock of the connector (A) as shown in the illustration to release it and disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Connector (A)
   *b	Connector (B)
   *c	Green-colored Lock
   	Slide

   WARNING:

   Make sure to wear insulated gloves.

   NOTE:

   Insulate the disconnected terminals and connector with insulating tape.

2. Disconnect the connector (B).
3. Remove the bolt and 2 nuts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Bolt
   	Nut

4. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor with motor assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002