Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced when inspecting auxiliary battery are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane Departure Alert System (w/ Steering Control) | Refer to INITIALIZATION [04/2018 - 08/2021] |
| Pre-Collision System | |||
| Intelligent Clearance Sonar System* | |||
| Lighting system (for HV Model with Cornering Light) | |||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [04/2018 -] | |
| Panoramic View Monitor System | Refer to INITIALIZATION [04/2018 -] |
*: When performing learning using the Techstream.
Refer to CALIBRATION [04/2018 -]