DTC Check / Clear [04/2018 - ]
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC
- Turn the power switch off.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Tilt & Telescopic / Trouble Codes.
Body Electrical > Tilt&Telescopic > Trouble Codes
- Read the DTCs.
Refer to DIAGNOSTIC TROUBLE CODE CHART [04/2018 - 08/2021] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2021 - ]
- CLEAR DTC
- Turn the power switch off.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Tilt & Telescopic / Trouble Codes.
Body Electrical > Tilt&Telescopic > Clear DTCs
- Clear the DTCs.