DTC Check / Clear [04/2018 - 08/2021]

WARNING: This page is about a different variant/trim than selected.

CHECK DTC AND FREEZE FRAME DATA (USING TECHSTREAM)
1. Turn the power switch off.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG).
4. Turn the Techstream on.
5. Enter the following menus: Chassis / Electric Parking Brake / Trouble Codes.
  Chassis > Electric Parking Brake > Trouble Codes
6. Check for DTCs.
7. Check the freeze frame data.
  1. If DTCs are output, check the freeze frame data and read the vehicle status when the DTC was stored.
  HINT:
  
  for Freeze Frame Data: Refer to FREEZE FRAME DATA [04/2018 - 08/2021]
CLEAR DTC AND FREEZE FRAME DATA (USING TECHSTREAM)
1. Turn the power switch off.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG).
4. Turn the Techstream on.
5. Enter the following menus: Chassis / Electric Parking Brake / Trouble Codes.
6. Clear the DTCs.
  Chassis > Electric Parking Brake > Clear DTCs
  
  HINT:
  
  When DTCs are cleared, the freeze frame data will also be cleared.