LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Avalon XLE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 65 (Air Conditioning System - Diagnostic Codes & Symptom Tests (Hybrid)) >> AIR CONDITIONING SYSTEM (for HV Model) >> Symptom Tests >> Recirculated/Fresh Air Modes do not Switch [04/2018 -] >> Procedure

Recirculated/Fresh Air Modes do not Switch [04/2018 -]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY 
    1. Check that the No. 1 blower damper servo sub-assembly is installed correctly.

      OK

      The No. 1 blower damper servo sub-assembly is installed correctly.

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY. Refer to  REASSEMBLY [04/2018 -] 

    Result: 

    OK 

    See step  2

  2. CHECK FOR DTC 
    1. Check for DTCs.

      Body Electrical > Air Conditioner > Trouble Codes 

      Result

      Result Proceed to
      B1442 is not output A
      B1442 is output B

    Result: 

    GO TO DTC B1442. Refer to  DTC B1442: Air Inlet Damper Control Servo Motor [04/2018 -]  

    Result: 

    See step  3

  3. READ VALUE USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Data List.
    5. Read the Data List according to the display on the Techstream.

      Powertrain > Engine > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up This is the engine coolant temperature.
      HINT: 
      • After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).
      • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.
      • If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.
      • Check if the engine overheats if the value indicated is higher than 135°C (275°F).

      Powertrain > Engine > Data List 

      Tester Display
      Coolant Temperature

      OK

      After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE AIR CONDITIONER UNIT ASSEMBLY. Refer to  REMOVAL [04/2018 - 08/2019]  , or refer to  REMOVAL [08/2019 - 08/2021]  , or refer to  REMOVAL [08/2021 -] 

    Result: 

    NG 

    GO TO COOLING SYSTEM. Refer to  ON-VEHICLE INSPECTION [04/2018 -]