Operation not Accepted Even If Air Conditioning Switch is Operated [04/2018 -]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR DTC
- Check for DTCs.
Body Electrical > Air Conditioner > Trouble Codes
Result
Result Proceed to B14B2 is not output A B14B2 is output B
Result:
B
GO TO DTC B14B2. Refer to DTC B14B2: Lost Communication with Front Panel LIN [04/2018 -]
Result:
A
See step 2
- Check for DTCs.
- CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND)
*a Front view of wire harness connector
(to Air Conditioning Amplifier Assembly)- Disconnect the G35 air conditioning amplifier assembly connector.
- Measure the voltage and resistance according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition G35-1 (B) - Body ground Power switch off 11 to 14 V G35-2 (IG+) - Body ground Power switch ON (IG) 11 to 14 V Power switch off Below 1 V Standard Resistance
Tester Connection Condition Specified Condition G35-4 (GND) - Body ground Always Below 1 Ω Result
Proceed to OK NG
Result:
OK
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY. Refer to REMOVAL [04/2018 - 08/2020] , or refer to REMOVAL [08/2020 -]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR