DTC P0010-01: Camshaft Position "A" Actuator Bank 1 General Electrical Failure [04/2018 -]: Procedure

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the cam timing control motor with EDU assembly.

   Refer to REMOVAL [04/2018 - 08/2021] , or refer to REMOVAL [08/2021 -]

2. Check if the eccentric shaft of the camshaft timing gear assembly rotates smoothly.
   NOTE:

   If the camshaft is at a position where a valve is about to open, the eccentric shaft may become difficult to rotate.

   OK

   Rotates smoothly.

   HINT: 

   Perform "Inspection After Repair" after replacing the camshaft timing gear assembly, or removing or replacing the cam timing control motor with EDU assembly.

   Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 -]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY. Refer to  REMOVAL [04/2018 - 08/2021]  , or refer to  REMOVAL [08/2021 -] 

Result: 

NG 

REPLACE CAMSHAFT TIMING GEAR ASSEMBLY. Refer to  PROCEDURE - Step 30 [04/2018 - 08/2019]  , or refer to  PROCEDURE - Step 30 [08/2019 -]